CopyRight 2012-2014 DS文库版权所有
织女星开发板RV32M1_Vega_Develop_Environment_Setup
(0 次评价)1809 人阅读0 次下载

 Setting Up RISC-V Development Environment for RV32M1-VEGA 1. Introduction This guide describes the setup for the RISC-V development environment of RV32M1-VEGA board. The RV32M1-VEGA development board is a small, low-power, and cost-effective evaluation and development board for application prototyping and demonstration of the RV32M1 device. The RV32M1 device integrates two RISC-V cores: a RI5CY core and a ZERO_RISCY core. There’s a JTAG port used to debug two RISC-V cores. For detailed information on the RV32M1 device, see RV32M1RM document. The setup for RIS-V development environment of RV32M1 includes installing GNU GCC toolchain, OpenOCD debugger, Eclipse and its configurations for RISC-V, and Software Development Kit (SDK) for RV32M1. The development system of RV32M1 RISC-V supports Windows, Linux, and MacOS operating system. In each operating system, you can set up a GUI-based development system with the Eclipse IDE or use command line simply if you prefer it. To set up the development system, you can follow one of the following guides according to your host operation system. • Windows • Linux • macOS WWW.OPEN - ISA .ORG RM32M1- VEGA User’s Guide Contents 1. Introduction ................................ ................................ ........ 1 2. Development Environment Setup on Windows ................. 2 2.1 Install Requirements and Dependencies .................. 2 2.2 Install Eclipse IDE for C/C++ Developers .............. 2 2.3 Install Windows Build Tools .................................. 2 2.4 Install RV32M1 GNU GCC Toolchain ................... 3 2.5 Install OpenOCD .................................................... 4 2.6 Install RV32M1 SDK.............................................. 6 2.7 Install CMake for Command Line Mode ................ 6 2.8 Install MinGW for Command Line Mode ............... 7 3. Development Environment Setup on Linux ....................... 8 3.1 Install RV32M1 GNU GCC Toolchain and CMake 8 3.2 Install OpenOCD .................................................... 8 3.3 Install Eclipse IDE for C/C++ Developers .............. 9 4. Development Environment Setup on MacOS .................... 9 4.1 Install RV32M1 GNU GCC Toolchain and CMake 9 4.2 Install OpenOCD .................................................. 10 5 References ........................................................................ 10 6 Revision history ............................................................... 10

打分:

0 星

用户评论:

小飞飞
于 2020-08-14 上传

版权及免责声明|RISC-V单片机中文网 |网站地图

GMT+8, 2022-10-5 07:59 , Processed in 0.497290 second(s), 30 queries .

返回顶部